Tweco Eliminator Spool Gun User Manual download pdf (Page 16)

4-12

safety and operating instructions

89200011

SECTION 4:

STANDARD SETUP

NOTE

Be certain that the end user (welder, operator, or helper) reads and understands

these instructions. Be certain that the welder also reads Section 2, "Safety

Precautions."

WARNING

Electric shock can cause injury or death.

The Eliminator Spool Gun requires 24VDC power for the motor inside the handle to feed the

wire from the spool. For power supplies having the capability to supply the 24VDC, no added

modules will be required to operate this MIG gun. A 10-pin amphenol plug is attached to the

cord coming out of the rear of the MIG gun that can be either attached directly to the mating

connection on the machine or through jump cords, refer to available options noted below:

Control Wire Jumper Cords

Manufacturer Machine Part Number Stock Number

Miller Millermatic 210 WSPMIU4PJC2 2031-2246

Miller Millermatic 212 WSPMILLOPJC 2031-2246

Lincoln Power MIG 255C WSPLIN7PJC 2031-2247

Hobart Ironman 210, 250 WSPMILL4PJC 2031-2245

Esab Migmaster 203 WSPESAB7PJC 2031-2248

Esab Migmaster 253 WSPESAB7PJC 2031-2248

Esab Migmaster 250 WSPESAB7PJC 2031-2248

Generic See pin conﬁguration WSPESAB7PJC 2031-2249

For those that cannot supply the 24VDC from a power source, Part No. ESG-1 Solid State

Control Box (Stock No. 1028-1295) will be required to interface with the power source. Refer

to Section 5 on the operation of the ESG-1 control box.

NOTE

When connecting the Spool gun to a Thermal Arc Arcmaster & Power Master

series power sources, use the Thermal Arc SGI-100 Spool Gun interface box.

Follow the set-up procedures outlined in the SGI-100 Instruction Manual, Form

No. 0-5061.

Standard Setup

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

No comments

Tweco Eliminator Spool Gun User Manual Page 16