Tweco Eliminator Spool Gun User Manual download pdf (Page 17)

safety and operating instructions

4-1389200011

Gas Supply

Control Cable

Gas Line

ESG-1 Control

Tweco

Spool Gun

(Gas and

Control Lines)

Tweco Spool Gun

Work Table

Power Cord

Weld Cables

Power Source

FRONT VIEW

REAR VIEW

STANDARD SYSTEM OUTLINE

Mount the control box on the power source and attach the MIG gun to the power source

by using the 25mm dinse connector supplied with the gun or if the power supply has a

stud, remove the connector from the MIG gun and attach the lug option (supplied) to the

gun to make this connection.

a) One (1) straight power lug is furnished with the MIG gun if the connection of the MIG gun

can only be made with a lug. Remove the dinse connector from the MIG gun by using a

5/32” allen wrench to remove the socket head cap screw found on the brass connector.

b) Using the ﬂat head cap screw furnished with the lug, place the lug on the brass block

and secure the lug in place. This connection must be wrench tight.

Using the jumper cord, Part No. SSG300-106JC (Stock No. 2031-2150), connect the 10-pin

amphenol plug attached to the gun to the mating connection on the jumper cord. The opposite

end of the jump cord has a 6-pin connection that connects to the ESG-1 box.

3. Locate the two (2) cords coming from the back of the control box, one will not have a connector

attached. Strip the ends of the 2 wire cable and install the proper terminals required to connect

into the trigger circuit on the power source.

NOTE

On some machines it may require the leads to be attached directly to the contactor

relay inside the power source.

4. Attach the gas hose from the rear of the MIG gun to the gas hose connection on the front

side of the control box.

5. Attach the gas hose from the ﬂow meter/regulator to the rear of the control box.

6. Plug the 120V cord coming out of the rear of the control box to a suitable 120V outlet.

NOTE

For more information on the control box read the instructions furnished with the

ESG-1 control box.

Standard Setup

Figure 4-1: ESG-1 Connection

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Comments to this Manuals

No comments

Tweco Eliminator Spool Gun User Manual Page 17

Comments to this Manuals

Related products and manuals for Hardware Tweco Eliminator Spool Gun