Tweco Eliminator Spool Gun User Manual download pdf (Page 7)

safety and operating instructions

2-389200011

SMOKE, FUMES, AND GASES CAN BE DANGEROUS TO YOUR HEALTH

Ventilation must be adequate to remove smoke, fumes, and gases during operation

to protect operators and others in the area. Vapors of chlorinated solvents can

form the toxic gas “Phosgene” when exposed to ultraviolet radiation from an

electric arc. All solvents, degreasers, and potential sources of these vapors must

be removed from the operating area. Use air-supplied respirators if ventilation

is not adequate to remove all fumes and gases. Oxygen supports, and vigorously accelerates ﬁre

and should never be used for ventilation.

See safety and operating references 1, 2, 3, and 4.

ARC RAYS, HOT SLAG, AND SPARKS CAN INJURE EYES AND BURN SKIN

Welding and cutting processes produce extreme localized heat and strong

ultraviolet rays. Never attempt to weld/cut without a federally compliant welding

helmet with the proper lens. A number 12 to 14 shade ﬁlter lens provides the

best protection against arc radiation. When in a conﬁned area, prevent the

reﬂected arc rays from entering around the helmet. Approved shielding curtains

and appropriate goggles should be used to provide protection to others in the surrounding area.

Skin should be protected from arc rays, heat, and molten metal. Always wear protective gloves

and clothing. All pockets should be closed and cuffs sewn shut. Leather aprons, sleeves, leggings,

etc. should be worn for out-of-position welding and cutting, or for heavy operations using large

electrodes. Hightop work shoes provide adequate protection from foot burns. For added protection,

use leather spats. Flammable hair preparations should not be used when welding/cutting. Wear

ear plugs to protect ears from sparks. Where work permits, the operator should be enclosed in

an individual booth painted with a low reflective material such as zinc oxide.

See safety and operating references 1, 2, and 3.

WELDING SPARKS CAN CAUSE FIRES AND EXPLOSIONS

Combustibles reached by the arc, ﬂame, ﬂying sparks, hot slag, and heated

materials can cause ﬁre and explosions. Remove combustibles from the work

area and/or provide a ﬁre watch. Avoid oily or greasy clothing as a spark may

ignite them. Have a ﬁre extinguisher nearby, and know how to use it. If welding/

cutting is to be done on a metal wall, partition, ceiling, or roof, precautions must

be taken to prevent ignition of nearby combustibles on the other side. Do not

weld/cut containers that have held combustibles. All hollow spaces, cavities, and containers

should be vented prior to welding/cutting to permit the escape of air or gases. Purging with inert

gas is recommended. Never use oxygen in a welding torch. Use only inert gases or inert gas

mixes as required by the process. Use of combustible compressed gases can cause explosions

resulting in personal injury or death. Arcing against any compressed gas cylinder can cause

cylinder damage or explosion. See safety and operating references 1, 2, 5, 7, and 8.

NOISE CAN DAMAGE HEARING

Noise from the air carbon-arc process can damage your hearing. Wear protective

hearing devices to ensure protection when noise levels exceed OHSA standards.

Adequate hearing protection devices must be worn by operators and surrounding

personnel to ensure personal protection against noise. See safety and operating

references 1, 2, and 6.

Safety Precautions

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Comments to this Manuals

No comments

Tweco Eliminator Spool Gun User Manual Page 7

Comments to this Manuals

Related products and manuals for Hardware Tweco Eliminator Spool Gun