Tweco Eliminator Spool Gun User Manual download pdf (Page 22)

8-18

safety and operating instructions

89200011

SECTION 8:

CHANGING OR REPLACING DRIVE ROLLS

1. Guns are shipped standard with 3/64” (1,2mm) drive rolls installed. Optional drive rolls

are available for .030” (0,8mm) through 1/16” (1,6mm) wire, see below table.

Optional Drive Rolls

Wire Size Part No. Stock No.

.030” (0,8mm) EPG103-2-0,8 2031-2091

.035” (0,9mm) EPG103-2-0,9 2031-2077

.040” (1,0mm) EPG103-2-1,0 2031-2023

3/64” (1,2mm) EPG103-2-1,2 2031-2003

1/16” (1,6mm) EPG103-2-1,6 2031-2022

2. To change or replace drive roll, loosen the setscrew on the drive roll with the allen wrench

furnished.

3. Remove the drive roll from the motor shaft and reinstall the new drive roll in its place.

NOTE

Make sure that the drive roll is seated against the brass washer before tightening

the set screw.

4. Drive rolls have two u-grooves in each roll and maybe inverted to double the life of one

drive roll.

Changing or Replacing Drive Rolls

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

No comments

Tweco Eliminator Spool Gun User Manual Page 22