Tweco Eliminator Spool Gun User Manual download pdf (Page 28)

13-24

safety and operating instructions

89200011

SECTION 13:

JUMP LINER INSTALLATION

When installing a jump liner, the following steps are recommended to install pieces into the

tube:

1. Remove the conductor tube by loosening the conductor screw cap, then loosen gas

diffuser set screw.

2. Remove jump liner from conductor tube.

3. Make sure that both new and old jump

liners are the same length. Feed the end of

the new jump liner into the conductor tube

until it stops. Secure with diffuser set screw.

If unsure if the liner is seated properly in

the diffuser, remove the set screw and liner

should be visible inside the set screw hole.

NOTE

Do not overtighten the set screw

on the jump liner or the bronze

material will collapse under

extreme pressure. The jump liner

should extend 3/16" (4,7mm) past

the rear ﬂat on the conductor tube.

4. Install conductor tube on the front of the

handle and twist locking nut clockwise to

secure. Insure that the liner in the tube is

seated in the front guide on gun before

tightening.

Jump Liner Installation

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

No comments

Tweco Eliminator Spool Gun User Manual Page 28